Topics
Articles about: Heating
14 articles
Choosing a machine · 9 min readTank size for engine reconditioning: heads, blocks, cranksEngine parts cleaning tank size, worked through: baskets for car and truck heads, cranks and blocks, the height and load limits, and when a lift is needed.
Choosing a machine · 9 min readSTS or SX: which benchtop ultrasonic cleaner for a workshopSTS and SX are both heated benchtop cleaners with degas and sweep. The SX adds power steps, pulse, memory and IP54. How to choose for workshop parts.
Choosing a machine · 7 min readSizing a hot-air dryer for basket and cycle timeSize a hot-air dryer around the loaded basket, water carried from the rinse and required output. Compare DT sizes without assuming a drying time.
Operation and maintenance · 8 min readSetting the dryer temperature controllerON/OFF or PID on a hot-air dryer: why the air overshoots, how to plan one auto-tune under real load, and why a factory reset loses the machine set-up.
Process and parameters · 8 min readDrying temperature by part materialChoose drying air temperature from the limits of the whole part. Compare steel, aluminium, copper alloys, plastics and assemblies with seals.
Parts and contaminants · 8 min readDrying plastic parts after cleaningDry plastic parts within the grade supplier’s limits. Plan low-temperature trials, open basket covers and checks for water, distortion and marks.
Operation and maintenance · 8 min readDryer maintenance: fan, heater and intake filterA hot-air dryer that slows down usually has a loaded filter, a blocked air path or a full drain, not a failed heater. What to check, and how often.
Operation and maintenance · 9 min readCommissioning a new ultrasonic tank: first fill to foil testThe first start-up of a new ultrasonic tank, in order: placing and connecting, first fill, timed heat-up, degassing, foil test and the day-one record.
Choosing a machine · 3 min readUMX Pro or ST series: two ways to build a 100-litre cleanerThe ST series is a floor tank with a separate generator cabinet; the UMX Pro is a cabinet with everything inside and a digital control panel. Same physics, different shop. Where each fits, with the overlapping models compared.
Operation and maintenance · 4 min readEnergy and running costs of an ultrasonic cleaning tankThe heater, not the ultrasound, is the cost. What a 96-litre and a 300-litre tank draw over a shift, where the kilowatt-hours go, and the four habits that cut the bill by a third: lid, timed heat-up, the right temperature, and a bath that lasts.
Choosing a machine · 3 min readDryer tanks: the DT series after the wash and rinseA hot-air drying tank the same size as the wash tank, so the basket goes from one to the other without repacking. What the DT series does, how long a basket takes to dry, and when a dryer is worth its floor space.
Process and parameters · 4 min readChoosing the cleaning temperatureHeat speeds up the chemistry and thins the oil, but above about 80 °C
Choosing a machine · 3 min readBenchtop or industrial: where the 30-litre line sits and whyBelow 30 litres
Choosing a machine · 2 min readChoosing the right ultrasonic cleaner: size, material, power and controlSize, frequency, power, tank material, timer and temperature control, brand and price: seven points to check before you choose a machine for the parts you clean.