-
Industrial ultrasonic cleaning, built around your parts.
Heated tanks, lift systems, filtration and spray washers from 2 to 8000 litres. Standard, or built to your specification.
-
Customisable units and much more.
Tank size, frequency, heating, filtration and handling are specified per order. Multi-tank lines are built around the sequence you run.
-
UMX Pro series: compact, digital, 50 to 255 litres.
Dual frequency, five programmes, degas and sweep as standard, filtration as a module. The digital end of the range in a small footprint.
What do you clean?
Tank size finder
Which tank fits your part?
Find out in ten seconds.
Enter the size of one part and how many you want to clean at a time. We show the smallest models whose usable tank takes the load.
Uses the usable tank dimensions from our own spec tables.
Find your machineTank size finder
An indication, not a quotation: basket design, fixtures and soil all change the answer. An engineer confirms the size.
Find your starting point
A system for your scale.
Three ways to bring ultrasonic cleaning into your workflow.
01 / BENCHTOPBenchtop
2 to 30 litres for the bench, the laboratory and the service counter.
2–30 L · 20 models
02 / INDUSTRIALIndustrial
Single-tank ultrasonic cleaners from 40 to 8000 litres, with filtration or lift, plus spray washers and hot-air dryers.
40–8000 L · 37 models03 / MULTI-TANK LINESMulti-tank lines
Manual, semi-automatic and automatic lines, built to your process.
1 modelIndustries
Industries we clean for
The same physics, a different part every time. Pick your sector to see which parts and which machines come up most.
From the bench to production
Explore the range.
Three starting points. Compare the model, then discuss the configuration for your process.
Start with the details
The right result starts with the right questions.
The component, the contamination and the next process all matter. We would rather ask than assume.
- Your parts and materials01
- Your cleaning requirements02
- Your production workflow03
A clear next step
From your component to a considered solution.
Understand the part.
Material, dimensions, contamination and the result you need.
Explore the process.
Tank format, handling, drying and your operating environment.
Define the next step.
A quotation, a cleaning trial, or a drawing to review.
Useful before we talk
A little detail goes a long way.
Bring your questions. These are good starting points for a conversation about your parts.
What should I have ready?
Part dimensions, material, what has to come off, how many parts per hour or per batch, and what happens to the part next. A photo or a drawing usually answers half the questions.
How do I choose a tank size?
Start from the basket, not the tank: the part has to sit with clearance on every side, and the batch has to fit without stacking parts on top of each other where the sound cannot reach. The usable tank dimension in our spec tables is the figure to measure against.
28 or 40 kHz?
28 kHz works harder and reaches heavier soil; 40 kHz is gentler and better on fine features and softer surfaces. Most industrial tanks can be supplied for either, and a sweep function keeps the field moving so the basket has no dead spots.
Become a distributor
Sell and service Sonixtek in your country
We are looking for distributors with their own service team. You get the full range from 2 to 8,000 litres, custom builds in your own brand, worldwide engineering support and protected territories.
Let's find the right fit
Not sure which size you need?
Send us the part, the quantity per hour and the soil you are removing. We will size the tank and the frequency with you.
