Topics
Articles about: Dryer tanks
13 articles
Choosing a machine · 7 min readSizing a hot-air dryer for basket and cycle timeSize a hot-air dryer around the loaded basket, water carried from the rinse and required output. Compare DT sizes without assuming a drying time.
Operation and maintenance · 8 min readSetting the dryer temperature controllerON/OFF or PID on a hot-air dryer: why the air overshoots, how to plan one auto-tune under real load, and why a factory reset loses the machine set-up.
Choosing a machine · 8 min readHot-air dryer or compressed-air blow-off?Compare compressed-air blow-off, a drip rack and a hot-air dryer through water retention, operator time, air use and the required handover.
Process and parameters · 8 min readDrying temperature by part materialChoose drying air temperature from the limits of the whole part. Compare steel, aluminium, copper alloys, plastics and assemblies with seals.
Parts and contaminants · 8 min readDrying plastic parts after cleaningDry plastic parts within the grade supplier’s limits. Plan low-temperature trials, open basket covers and checks for water, distortion and marks.
Parts and contaminants · 8 min readDrying filter cartridges and parts with internal channelsWashed filter cartridges and channelled parts dry outside first and stay wet inside. Load them flat, guide the air through, filter the intake, check the core.
Process and parameters · 8 min readDrying blind holes and threads after washingBlind holes can stay wet after the outside dries. Set part orientation, draining and hot-air exposure, then check the feature that holds water.
Industries · 8 min readDrying and documentation in audited plantsWhat an audited plant asks for about a drying station: manual, cleaning and maintenance plan, wiring diagram, spare parts list and the records behind them.
Operation and maintenance · 8 min readDryer maintenance: fan, heater and intake filterA hot-air dryer that slows down usually has a loaded filter, a blocked air path or a full drain, not a failed heater. What to check, and how often.
Process and parameters · 4 min readRinsing and drying after ultrasonic cleaningThe wash lifts the soil; the rinse takes the wash off the part; the dryer takes the rinse off. Skip either and the part carries a film of detergent, or water in every blind hole. How each stage is done, from a bucket to a DT dryer tank.
Choosing a machine · 3 min readMulti-tank lines: wash, rinse, dryWhen a clean part has to come out dry and residue-free, one tank is not enough. How a wash, rinse and dry line is laid out, how a transport carriage moves the basket through it, and how to decide the number of stations from the cleanliness you need.
Choosing a machine · 3 min readDryer tanks: the DT series after the wash and rinseA hot-air drying tank the same size as the wash tank, so the basket goes from one to the other without repacking. What the DT series does, how long a basket takes to dry, and when a dryer is worth its floor space.
Choosing a machine · 2 min readOther types of industrial parts cleanersSpray-jet washers and dryer tanks next to the ultrasonic bath: what each one does, and when a line combines them.