Topics
Articles about: Degreasing
13 articles
Ultrasonic cleaning basics · 4 min readUltrasonic cleaning compared with brushing, soaking and sprayingBrushing, soaking, spray washing and solvent wiping each clean some parts well and others badly. How ultrasonic cleaning compares on reach into holes and threads, labour, repeatability and care of the surface, where it falls short, and how the methods combine in one line.
Parts and contaminants · 10 min readOne ultrasonic tank for the plant maintenance workshopPumps, valves, bearings and gears in one tank: size it from your largest regular part, choose frequency and cleaner, and know when filtration pays.
Choosing a machine · 7 min readReplacing solvent degreasing with aqueous ultrasonicsReplace solvent degreasing by assessing the complete wash, rinse and dry route: soil, material compatibility, bath control and checks on the part.
Parts and contaminants · 9 min readRemoving drawing and stamping oils from stamped partsDegreasing stamped parts in bulk: why flat parts nest and overload the bath, how to work out the oil load, and the loading, filtration, rinse and drying.
Parts and contaminants · 6 min readCleaning starter and alternator housingsCleaning stripped starter and alternator housings: choose an aluminium-compatible bath, protect bearing seats, rinse passages and verify drying.
Parts and contaminants · 4 min readUltrasonic cleaning of battery components before assemblyCell cans, lids, tabs, busbars, housings and cooling plates carry oil and particles into welding and bonding. How to clean them; cells never go in a bath.
Parts and contaminants · 4 min readUltrasonic cleaning of bearings and mechanical componentsOld grease, wear particles and dirt out of dismounted bearings, gears and couplings so they can be inspected and reused. Which bearings to clean and which never to wash, the settings, and the steps that stop a clean bearing from rusting or being damaged before it is greased again.
Parts and contaminants · 4 min readCleaning parts before coating or painting with ultrasoundPaint, powder, plating and bonding fail on oil, fingerprints and residue. The cleaning sequence in front of a coating line, how to test that a surface is ready, the contaminants that cause craters and blisters, and how ultrasonic cleaning fits with conversion coatings and pretreatment.
Parts and contaminants · 5 min readRemoving oil and greaseOil is the easiest soil for an ultrasonic bath and the one that kills the bath fastest. Chemistry, temperature and time for light machine oil, chassis grease and waxy lubricants, and why the skimmer matters more than the transducers once the parts come out clean.
Parts and contaminants · 3 min readRemoving heavy grease and sludge from engine partsCrankshafts, connecting rods, sumps, timing covers and gearbox cases come in coated in oil, sludge and road grime. The hot soak, the ultrasonic cycle and the skimmer that let one bath degrease a week of engine rebuilds instead of a day.
Parts and contaminants · 4 min readUltrasonic cleaning of carburettors: the complete processVarnish, gum and carbon out of jets, emulsion tubes and drillings without hours of wire and spray can. Strip-down, liquid, temperature, frequency and time for aluminium and zinc bodies, and what must never go in the bath.
Process and parameters · 4 min readCleaning liquids for ultrasonic cleaningWater with a detergent does most jobs. Which chemistry for oil, carbon, oxide and flux, what never goes in the tank, and why concentration and temperature matter as much as the product.
Choosing a machine · 3 min readSpray washer or ultrasonic bathA rotating spray washer throws hot detergent at the part from nozzles as the basket turns; an ultrasonic bath immerses it. One is fast on big, open parts with gross soil; the other reaches inside. The SPR series, what it is good at, and the lines that use both.