Knowledge
Operation and maintenance
Bath care, filtration, safety, the foil test, troubleshooting: keeping a machine cleaning as it did on day one.
11 articles
Operation and maintenance · 8 min readSetting the dryer temperature controllerON/OFF or PID on a hot-air dryer: why the air overshoots, how to plan one auto-tune under real load, and why a factory reset loses the machine set-up.
Operation and maintenance · 7 min readMonitoring a cleaning bath: concentration, oil and changeWeekly titration, an oil balance in grams, a filter routine and a batch log: how to monitor an ultrasonic cleaning bath and decide when to change it.
Operation and maintenance · 8 min readDryer maintenance: fan, heater and intake filterA hot-air dryer that slows down usually has a loaded filter, a blocked air path or a full drain, not a failed heater. What to check, and how often.
Operation and maintenance · 9 min readCommissioning a new ultrasonic tank: first fill to foil testThe first start-up of a new ultrasonic tank, in order: placing and connecting, first fill, timed heat-up, degassing, foil test and the day-one record.
Operation and maintenance · 11 min readLaminar flow in an ultrasonic tank: what it does and which machines have itLaminar flow carries floating oil and dirt across the bath surface to an overflow, so parts leave through clean liquid. How it works, upkeep, which ranges.
Operation and maintenance · 4 min readTroubleshooting: the machine runs but the parts are not cleanNine causes cover almost every case, and seven of them are the bath or the loading, not the machine. A checklist in the order that finds the fault fastest, from the sound of the tank to the generator display.
Operation and maintenance · 3 min readThe foil test: a one-minute check of cavitationA sheet of household aluminium foil in the bath for sixty seconds shows where the tank cleans and where it does not. How to run it, what the hole pattern means, and how to use it as the acceptance test for a new machine and the monthly check for an old one.
Operation and maintenance · 4 min readSafety around an ultrasonic cleaning tankHot alkaline liquid, a running bath that causes pain and tissue damage to a hand put into it, noise above the hearing range that is still noise, fumes, and heavy baskets over an open tank. The hazards of an industrial cleaner, and the habits and fittings that control them.
Operation and maintenance · 4 min readEnergy and running costs of an ultrasonic cleaning tankThe heater, not the ultrasound, is the cost. What a 96-litre and a 300-litre tank draw over a shift, where the kilowatt-hours go, and the four habits that cut the bill by a third: lid, timed heat-up, the right temperature, and a bath that lasts.
Operation and maintenance · 3 min readDaily and weekly maintenance of an ultrasonic cleanerAn ultrasonic tank has no wear parts in the liquid, so maintenance is about the bath, the floor, the filter and the heater. A routine that takes ten minutes a day and half an hour a week, and what to look at once a month.
Operation and maintenance · 2 min readAccessories for ultrasonic cleaningCooling systems and bubble tanks: two add-ons that bring the bath back to its set temperature and loosen remaining residue without manual rinsing.