Topics
Articles about: Cavitation
10 articles
Ultrasonic cleaning basics · 4 min readUltrasonic cleaning compared with brushing, soaking and sprayingBrushing, soaking, spray washing and solvent wiping each clean some parts well and others badly. How ultrasonic cleaning compares on reach into holes and threads, labour, repeatability and care of the surface, where it falls short, and how the methods combine in one line.
Ultrasonic cleaning basics · 7 min readUltrasonic cleaning explained: cavitation, frequency, temperature and equipmentThe long version. How a sound field makes cavitation, what frequency, power and temperature change, how the cleaner fits in, what the generator, transducers and tank do, which functions matter, and which type of machine suits which work.
Ultrasonic cleaning basics · 3 min readCavitation: how a collapsing bubble cleans a surfaceUltrasound does not scrub. It makes millions of microscopic bubbles grow and collapse against the part every second, and the collapse does the work. What happens in the liquid, and what it means for the settings you choose.
Ultrasonic cleaning basics · 3 min readUltrasonic power density: watts per litre, and why big tanks need fewerDivide the ultrasonic power by the tank volume and you get the figure that predicts how hard a tank cleans. Our range runs from about 9 to 40 W per litre, and the spread is deliberate. How to read the number when comparing machines.
Operation and maintenance · 3 min readThe foil test: a one-minute check of cavitationA sheet of household aluminium foil in the bath for sixty seconds shows where the tank cleans and where it does not. How to run it, what the hole pattern means, and how to use it as the acceptance test for a new machine and the monthly check for an old one.
Ultrasonic cleaning basics · 3 min readSweep and degas: what the two buttons on a digital generator doSweep moves the frequency a little either side of nominal so no part sits in a dead spot; degas drives dissolved air out of a fresh bath so cavitation can start. When to use each, and what happens if you do not.
Process and parameters · 4 min readChoosing the cleaning temperatureHeat speeds up the chemistry and thins the oil, but above about 80 °C
Process and parameters · 2 min read28 kHz or 40 kHz: which frequency cleans your part?Lower frequency hits harder, higher frequency reaches further. The part, the soil and the surface decide.
Process and parameters · 2 min readAgitation in ultrasonic cleaningMoving the basket while the ultrasound runs exposes every face of the part to fresh cavitation and stops standing-wave shadows. When it helps and how the lift does it.
Ultrasonic cleaning basics · 2 min readWhy ultrasonic cleaning reaches where brushes cannotCavitation cleans blind holes, threads and internal passages that scrubbing and soaking leave dirty. What the process is, where it is used and what to expect.